Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here



AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
  1. The headlight leveling ECU assembly operates in fail-safe mode if an abnormal condition such as those listed below has been detected, and keep the last low beam status.

    Item
    Abnormality Detection Condition
    Return Condition
    Warning Indicator
    Height control sensor power source voltage
    Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected.
    Voltage of 4.61 to 6.24 V is detected
    Illuminated
    Height control sensor signal voltage
    Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected.
    Voltage of 0.26 to 4.74 V is detected
    IG power source voltage
    Abnormal high power source voltage (18.1 V or more) is detected.
    Voltage of 17.5 V or less is detected
    Not illuminated
    Abnormal low power source voltage (9.0 V or less) is detected.
    Voltage of 9.3 V or more is detected for 0.1 seconds
    Not illuminated
    Abnormal height control sensor signal while initialization
    Initialization is performed outside the valid range of the voltage for initialization.
    Initialization is successfully completed within the valid range of the voltage for initialization.
    Illuminated