Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. The ECM turns on the cruise control indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.
  2. The cruise control indicator light illuminates in green when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator light changes to amber.
  3. The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

WIRING DIAGRAM


E230248E16


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Select the following menu items: Body Electrical / Combination Meter / Active Test.

  1. Check the cruise control indicator light by performing the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    Cruise control indicator light
    Cruise control indicator light (illuminated in green) ON / OFF
    -
    Cruise Warning
    Cruise control indicator light
    Cruise control indicator light (illuminated in amber) ON / OFF
    -

    OK:
    The cruise control indicator light goes on or off.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)