FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Power train / Engine / Active Test / Control the Fuel Pump / Speed.
Check the fuel pump operation.
Check for pressure in the fuel inlet tube from the fuel line. Check that sound of fuel flowing in the fuel tank can be heard.
If no sound can be heard, check the EFI MAIN 1 relay, fuel pump, ECM and wiring connector.
Inspect for fuel leaks.
Check that there are no fuel leaks anywhere on the system after performing maintenance.
If there is a fuel leak, repair or replace parts as necessary.
| 2. CHECK FUEL PRESSURE |
Check that the battery positive voltage is above 12 V.
Discharge the fuel system pressure (Click here).
Disconnect the cable from the negative (-) battery terminal.
Disconnect the No. 2 fuel tube. (Direct injection side) (for metal type)
![]() |
Loosen the hose clamp and disconnect the No. 2 fuel tube.
Disconnect the No. 2 fuel hose. (Direct injection side) (for clamp type)
![]() |
Loosen the hose clamp and disconnect the No. 2 fuel hose.
Disconnect the fuel tube. (Port injection side) (for metal type)
![]() |
Loosen the hose clamp and disconnect the fuel tube.
Disconnect the fuel hose. (Port injection side) (for clamp type)
![]() |
Loosen the hose clamp and disconnect the fuel hose.
![]() |
Install SST (pressure gauge) as shown in the illustration.
| *1 | SST (Pressure Gauge) |
| *2 | SST (Straight joint) |
| *3 | SST (Hose) |
| *4 | SST (T-joint) |
| *5 | SST (Hose Band) |
| *6 | SST (Clip) |
Wipe off any gasoline.
Reconnect the cable to the negative (-) battery terminal.
Operate the fuel pump.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Power train / Engine / Active Test / Control the Fuel Pump / Speed.
Measure the fuel pressure.
Start the engine.
Measure the fuel pressure when idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST and the fuel tube connector to prevent fuel from spilling.
Reconnect the No. 2 fuel tube with the clamp. (Direct injection side) (for metal type)
Reconnect the No. 2 fuel hose with the clamp. (Direct injection side) (for clamp type)
Reconnect the fuel tube with the clamp. (Port injection side) (for metal type)
Reconnect the fuel hose with the clamp. (Port injection side) (for clamp type)
Inspect for fuel leaks (Step 1).
| 3. CHECK FUEL PRESSURE (for High Pressure) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Start and warm up the engine.
Run the engine at idle.
Enter the following menus: Power train / Engine / Data List / Fuel Press.
Check the high pressure side fuel pressure.
Stop the engine.