Home › Engine / Hybrid System › FA20 INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A278294
  1. Disengage the 7 clips and remove the 12 bolts and No. 1 engine under cover.



2. REMOVE NO. 2 ENGINE UNDER COVER


    A278295
  1. Remove the 7 bolts and the No. 2 engine under cover.



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A277952
  1. Remove the 2 nuts and disconnect the exhaust joint pipe.



    A277953
  1. Remove the 2 nuts and the 2 bolts.

  1. Remove the 2 compression springs and disconnect the center exhaust pipe assembly.



    A277954
  1. Remove the bolt and the front exhaust pipe assembly.

  1. Remove the 2 gaskets.



4. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A277955
  1. Remove the 2 nuts and 2 bolts, and disconnect the tail exhaust pipe assembly.



    A277956
  1. Remove the cushion rubber and the center exhaust pipe assembly.

  1. Remove the gasket.



5. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    C262505
  1. Remove the 4 cushion rubbers and the tail exhaust pipe assembly.



6. REMOVE TAIL PIPE BAFFLE (w/ Rear Spoiler)
  1. Remove the 2 bolts and the 2 tail pipe baffles.



7. REMOVE FRONT EXHAUST PIPE SUB-ASSEMBLY


    A276566E01
  1. Set the SST.

    SST
    09250-53010  

  1. Remove the rope that is tying the joint pipe to the front suspension cross member sub-assembly.

  1. Remove the exhaust joint pipe.