Home › Engine / Hybrid System › FA20 FUEL › FUEL PUMP

FUEL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A280590E01
  1. Apply a light coat of gasoline to new 2 O-rings, and install the 2 O-rings and backup ring to the fuel pressure regulator assembly.
    Text in Illustration 
    *1
    O-Ring
    *2
    Backup Ring



    A280589
  1. Install the fuel pressure regulator assembly to the fuel filter.



2. INSTALL FUEL PUMP ASSEMBLY


    A280588E01
  1. Install the new O-ring and fuel pump spacer to the fuel pump assembly.
    Text in Illustration 
    *1
    Fuel Pump Wire harness
    *2
    O-Ring
    *3
    Fuel Pump Spacer

  1. Connect the new fuel pump wire harness to the fuel pump assembly.



    A280591
  1. Apply a light coat of gasoline to a seal, and install it to the fuel pump assembly.

  1. Attach the 5 claws of the fuel filter to install the fuel pump assembly.

    NOTICE:
    When installing the seal, make sure that it does not become pinched or cut.



3. INSTALL NO. 1 FUEL SUB-TANK
  1. Set the fuel suction plate sub-assembly to the No. 1 fuel sub-tank using the spring.



    A269036E01
  1. Apply a light coat of gasoline to a new O-ring and install the O-ring to the jet pump.
    Text in Illustration 
    *1
    Jet Pump

  1. Install the jet pump to the No. 1 fuel sub-tank.

    NOTICE:
    1. When installing the O-ring, make sure that it does not become pinched or cut.
    2. Securely attach the claws.



    A280583
  1. Attach the 3 claws to install the fuel filter assembly to the No. 1 fuel sub-tank.



    A281165
  1. Attach the claw to install the jet pump nozzle to the No. 1 fuel sub-tank.



    A121017
  1. Install a new E-ring.



    A277999
  1. Connect the connector.



4. INSTALL FUEL SENDER GAGE ASSEMBLY


    A281948E01
  1. Slide the fuel sender gauge assembly downwards and attach the claw labeled A to install the fuel sender gauge assembly.
    Text in Illustration 
    V100135
    Slide

  1. Connect the fuel pump harness to the 2 clamps.

  1. Connect the fuel sender gauge assembly connector.