FUEL PUMP > DISASSEMBLY |

| 1. REMOVE FUEL SENDER GAGE ASSEMBLY |
![]() |
Disconnect the fuel sender gauge assembly connector.
Disconnect the fuel pump harness from the 2 clamps.
![]() |
Disconnect the fuel pump harness from the clamp.
Push the claw labeled A of the fuel sender gauge assembly, and then pull up the fuel sender gauge assembly to remove it.
![]() | Push |
![]() | Pull up |
| 2. REMOVE NO. 1 FUEL SUB-TANK |
![]() |
Disconnect the connector.
![]() |
Hold the fuel suction plate sub-assembly in the direction of the arrow as shown in the illustration.
Using needle nose plier, remove the E-ring.
![]() |
Using a screwdriver with the tip taped, disengage the claw and separate the jet pump nozzle.
| *1 | Protective Tape |
![]() |
Using a screwdriver with the tip taped, disengage the 3 claws and separate the No. 1 fuel sub-tank.
![]() |
Using a screwdriver with the tip taped, disengage the claw and separate the jet pump.
![]() |
Remove the O-ring from the No. 1 fuel sub-tank.
| 3. REMOVE FUEL PUMP ASSEMBLY |
![]() |
Using 2 screwdrivers with the tip taped, disengage the 2 claws.
![]() |
Using a screwdriver with the tip taped, disengage the 3 claws and remove the fuel pump.
![]() |
Disconnect the connector, and remove the fuel pump wire harness.
Remove the O-ring and fuel pump spacer from the fuel pump assembly.
| *1 | fuel pump wire harness |
| *2 | O-Ring |
| *3 | Fuel Pump Spacer |
| 4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Remove the fuel pressure regulator assembly from the fuel filter.
![]() |
Remove the 2 O-ring and backup ring from the fuel pressure regulator assembly.
| *1 | O-Ring |
| *2 | Backup Ring |