CYLINDER BLOCK > DISASSEMBLY |
| 1. REMOVE PISTON SUB-ASSEMBLY WITH CONNECTING ROD |
Mark each connecting rod cap and piston with a cylinder number.
Turn the crankshaft so that the connecting rod cap can be removed.
![]() |
Using a "TORX" socket wrench E14, remove the 2 connecting rod cap bolts and connecting rod cap.
![]() |
Turn the crankshaft and separate the crank pin from the connecting rod.
| *1 | Crank pin |
| *2 | Connecting rod |
![]() |
Push the connecting rod in the direction of the arrow, and remove the piston with connecting rod from the cylinder block.
| 2. REMOVE CYLINDER BLOCK SUB-ASSEMBLY (for Bank 1) |
Operate the engine stand so that the bank 1 side faces upward.
![]() |
Remove the 5 bolts.
![]() |
Using a 12 mm socket wrench, loosen the 10 bolts in the order as shown in the illustration.
Remove the 10 bolts and cylinder block (for bank 1).
| 3. REMOVE CRANKSHAFT |
![]() |
Remove the crankshaft from the cylinder block (for bank 2).
| 4. REMOVE REAR ENGINE OIL SEAL |
Remove the rear engine oil seal.
| 5. REMOVE O-RING |
![]() |
Remove the O-ring from the cylinder block (for bank 2).
| 6. REMOVE CRANKSHAFT BEARING |
![]() |
Remove the crankshaft bearings from the cylinder block (for bank 1) and cylinder block (for bank 2).
| *1 | No. 1 and No. 3 Crankshaft Bearing |
| *2 | No. 2 and No. 4 Crankshaft Bearing |
| *3 | No. 5 Crankshaft Bearing |
| *a | for Bank 1 |
| *b | for Bank 2 |
| 7. REMOVE OIL SEPARATOR COVER |
![]() |
Remove the 7 bolts and oil separator cover from the cylinder block (for bank 1).
| 8. REMOVE CYLINDER BLOCK SUB-ASSEMBLY (for Bank 2) |
Remove the cylinder block sub-assembly (for bank 2) from the engine stand.
| 9. REMOVE CYLINDER BLOCK PLATE |
![]() |
Remove the 5 bolts and cylinder block plate from the cylinder block (for bank 2).
| 10. REMOVE CRANKSHAFT SENSOR HOLDER ASSEMBLY |
![]() |
Remove the 2 bolts and crankshaft sensor holder assembly from the cylinder block (for bank 2).
| 11. REMOVE NO. 1 CYLINDER BLOCK TIGHT PLUG |
![]() |
Remove the 3 No. 1 cylinder block tight plugs from the cylinder block (for bank 1) and cylinder block (for bank 2).
| *a | for Bank 1 |
| *b | for Bank 2 |
| 12. REMOVE CONNECTING ROD BEARING |
Remove the connecting rod bearings.
| 13. REMOVE PISTON RING SET |
![]() |
Using a piston ring expander, remove the No. 1 compression ring and No. 2 compression ring in order.
Remove the upper oil ring side rail, lower oil ring side rail and oil ring expander in order by hand.
| 14. REMOVE PISTON WITH PIN SUB-ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the piston pin hole snap ring on one end from the piston.
| *1 | Protective Tape |
Remove the piston pin from the piston.
Using a screwdriver with its tip wrapped in protective tape, remove the piston pin hole snap ring on other end from the piston.