Home › Engine / Hybrid System › FA20 ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > REMOVAL

for Preparation Click here



1. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A283417
  1. Loosen the hose clamp and disconnect the No. 2 ventilation hose.



    A283418
  1. Disconnect the mass air flow meter connector.

  1. Disengage the clamp and separate the wire harness from the air cleaner cap.



    A283419
  1. Loosen the 2 hose clamps.



    A283420
  1. Remove the 3 bolts and the air cleaner cap with air cleaner hose.



2. REMOVE GENERATOR COVER


    A276031
  1. Remove the 2 bolts and generator cover.



3. REMOVE BELT GENERATOR COVER


A276032
  1. Disengage the 2 clamps and separate the wire harness from the belt generator cover.

  1. Remove the 2 bolts and belt generator cover.



4. REMOVE FAN AND GENERATOR V BELT


A316371E01
  1. While turning the belt tensioner clockwise, align the holes and insert a 3 mm (0.118 in.) hexagon wrench into the holes to hold the belt tensioner.
    Text in Illustration 
    *1
    Hexagon Wrench

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the fan and generator V belt from the belt tensioner.