Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > ON-VEHICLE INSPECTION

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicles.
  2. The procedure listed below is for the LHD vehicles.



1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY


  1. for LH Side



      B314877E01
    1. Operate the windshield wiper motor assembly.

    2. Stop the windshield wiper motor assembly operation.

    3. Check the automatic stop (park) position.

      Standard:
      Area
      Standard Condition
      a
      35.0 mm (1.378 in.)

      Text in Illustration 
      *1
      Ceramic Dot
      *2
      Cowl Panel End

      HINT:
      After the front wiper motor stops, check the automatic stop position after lifting the wiper blade 2 times.

      OK:
      The front wipers stop at the positions shown in the illustration.



  1. for RH Side



      B314876E01
    1. Operate the windshield wiper motor assembly.

    2. Stop the windshield wiper motor assembly operation.

    3. Check the automatic stop (park) position.

      Standard:
      Area
      Standard Condition
      a
      33.0 mm (1.299 in.)

      Text in Illustration 
      *1
      Ceramic Dot
      *2
      Cowl Panel End

      HINT:
      After the front wiper motor stops, check the automatic stop position after lifting the wiper blade 2 times.

      OK:
      The front wipers stop at the positions shown in the illustration.