Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD

STEERING PAD > INSTALLATION

for Preparation Click here



1. INSTALL HORN BUTTON ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



  1. for Dual Airbag System



      B311945E01
    1. Connect the 2 airbag connectors to the horn button assembly.
      Text in Illustration 
      *1
      Airbag Connector
      *2
      Horn Connector
      *3
      Airbag Connector Lock

      NOTICE:
      1. When connecting any airbag connector, take care not to damage the airbag wire harness.
      2. Be sure to only connect the connectors to each corresponding color.

    2. Push in the 2 locks to install the 2 airbag connectors.

      NOTICE:
      Make sure that the horn button assembly is securely installed.

    3. Connect the horn connector to the horn button assembly.



  1. for Single Airbag System



      B311353E01
    1. Connect the airbag connector to the horn button assembly.
      Text in Illustration 
      *1
      Airbag Connector
      *2
      Horn Connector
      *3
      Airbag Connector Lock

      NOTICE:
      When connecting any airbag connector, take care not to damage the airbag wire harness.

    2. Push in the lock to install the airbag connector.

      NOTICE:
      Make sure that the horn button assembly is securely installed.

    3. Connect the horn connector to the horn button assembly.



    B311354
  1. Push the horn button assembly to engage the 3 pins carefully.

    NOTICE:
    1. Make sure that the pins are securely inserted into the steering holes.
    2. Make sure that the horn button assembly is securely installed.

  1. Install the No. 1 and No. 2 lower steering wheel covers.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



3. INSPECT HORN BUTTON ASSEMBLY
  1. Make sure that the horn sounds.
    If the horn does not sound, inspect the horn system (Click here).



4. INSPECT SRS WARNING LIGHT
(Click here)