STEERING PAD > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE HORN BUTTON ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Using a screwdriver wrapped with protective tape, remove the No. 1 and No. 2 lower steering wheel covers.
| *1 | Protective Tape |
![]() |
Using a screwdriver, push in the 3 torsion springs to disengage the 3 pins.
| *1 | Torsion Spring |
Pull out the horn button assembly from the steering wheel assembly and support the horn button assembly with one hand.
for Dual Airbag System
![]() |
Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Horn Connector |
| *4 | Airbag Connector Lock |
Disconnect the 2 airbag connectors to remove the horn button assembly.
Disconnect the horn connector from the horn button assembly.
for Single Airbag System
![]() |
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Horn Connector |
| *4 | Airbag Connector Lock |
Disconnect the airbag connector to remove the horn button assembly.
Disconnect the horn connector from the horn button assembly.