SIDE AIRBAG SENSOR (for Rear Side) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY |
![]() |
Remove the bolt.
Disengage the hook and remove the separate type rear seat cushion assembly LH.
| 4. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 6 claws and remove the front door scuff plate LH.
| 5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 6. REMOVE LUGGAGE COMPARTMENT TRIM COVER |
![]() |
Remove the 3 clips.
Disengage the 8 clips and remove the luggage compartment trim cover LH.
| 7. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Using a screwdriver with the tip wrapped with protective tape, release the pretensioner connector lock and disconnect the pretensioner connector.
| *1 | Protective Tape |
| *2 | Pretensioner Connector |
| *3 | Pretensioner Connector Lock |
![]() |
Remove the 2 bolts and disengage the guide to remove front seat outer belt assembly.
| 8. REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Remove the nut and separate the No. 2 side airbag sensor assembly from the vehicle body.

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Slide | *b | Push |
Disconnect the connector to remove the No. 2 side airbag sensor assembly.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)
Push down the white housing lock again and disconnect the connector.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Correct | *b | Incorrect |