KNEE AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (When Installed in Vehicle) |
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the instrument side cover .
Remove the No. 1 instrument panel under cover sub-assembly .
Disconnect the lower No. 1 instrument panel airbag connector.
Using a screwdriver with the tip wrapped with protective tape, disconnect the airbag connector.
Install SST.
![]() |
Connect the clip and terminal of SST.
| *a | Connect the clip and terminal |
Connect the SST connector to the lower No. 1 instrument panel airbag assembly.
![]() |
Move SST at least 10 m (32.8 ft.) away from the front side window of the vehicle.
| *1 | Battery |
| *a | 10 m (32.8 ft.) or more |
Maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the lower No. 1 instrument panel airbag assembly.
| 3. DISPOSE OF LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (When not Installed in Vehicle) |
Remove the lower No. 1 instrument panel airbag assembly (Click here).
![]() |
Using braided wire, tie down the lower No. 1 instrument panel airbag assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *a | Wire Diameter |
Position the lower No. 1 instrument panel airbag assembly inside the tire with the airbag deployment side facing inside.

| *a | Width | *b | Inner Diameter |
Install SST.
![]() |
Connect the clip and terminal of SST.
| *a | Connect the clip and terminal |
After connecting the following SST to each other, connect them to the lower No. 1 instrument panel airbag assembly.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the lower No. 1 instrument panel airbag assembly is tied.
| *1 | Tires (2 or more) |
Place at least 2 tires onto the tire to which the lower No. 1 instrument panel airbag assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
![]() |
Deploy the airbag.
| *1 | Lower No. 1 Instrument Panel Airbag Assembly |
| *2 | Battery |
| *a | 10 m (32.8 ft.) or more |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the lower No. 1 instrument panel airbag assembly is tied.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy lower No. 1 instrument panel airbag assembly.
Dispose of the lower No. 1 instrument panel airbag assembly.
Remove the lower No. 1 instrument panel airbag assembly from the tire.
Place the lower No. 1 instrument panel airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.