FRONT PASSENGER AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (When Installed in Vehicle) |
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the lower instrument panel sub-assembly (Click here).
Disconnect the No. 2 instrument panel wire.
![]() |
Slide the slider to release the lock, and then disconnect the connector.
| *1 | Slider |
Install SST.
![]() |
Connect the clip and terminal of SST.
| *a | Connect the clip and terminal |
After connecting the following SST to each other, connect them to the instrument panel passenger airbag assembly.
Connect the SST connector to the No. 2 instrument panel wire.
![]() |
Move SST at least 10 m (32.8 ft.) away from the front side window of the vehicle.
| *1 | Battery |
| *a | 10 m (32.8 ft.) or more |
Maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the instrument panel passenger airbag assembly.
| 3. DISPOSE OF INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (When not Installed in Vehicle) |
Remove the instrument panel passenger airbag assembly (Click here).
Install SST.
![]() |
Connect the clip and terminal of SST.
| *a | Connect the clip and terminal |
After connecting the following SST to each other, connect them to the instrument panel passenger airbag assembly.
![]() |
Using braided wire, tie down the instrument panel passenger airbag assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *a | Wire Diameter |
Position the instrument panel passenger airbag assembly inside the tire with the airbag deployment side facing inside.

| *a | Inner Diameter | *b | Width |
Place the tires.
![]() |
Place at least 2 tires under the tire to which the instrument panel passenger airbag assembly is tied.
| *1 | Tires (2 or more) |
Place at least 2 tires onto the tire to which the instrument panel passenger airbag assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
![]() |
Deploy the airbag.
| *1 | Instrument Panel Passenger Airbag Assembly |
| *2 | Battery |
| *a | 10 m (32.8 ft.) or more |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the instrument panel passenger airbag assembly is tied.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the instrument panel passenger airbag assembly.
Dispose of the instrument panel passenger airbag assembly.
Remove the instrument panel passenger airbag assembly from the tire.
Place the instrument panel passenger airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.