CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (When Installed in Vehicle) |
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the quarter trim rid sub-assembly .
Disconnect the curtain shield airbag assembly connector.
![]() |
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Airbag Connector Lock |
Install SST.
Connect the clip and terminal of SST.
![]() |
After connecting the following SST to each other, connect them to the curtain shield airbag assembly.
| *a | Connect the clip and terminal |
![]() |
Move SST at least 10 m (32.8 ft.) away from the rear side window.
| *1 | Battery |
| *a | 10 m (32.8 ft.) or more |
Maintaining sufficient clearance for the SST wire harness in the rear side window, close all doors and windows of the vehicle.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the curtain shield airbag assembly.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the curtain shield airbag assembly.
| 3. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (When not Installed in Vehicle) |
Remove the curtain shield airbag assembly (Click here).
![]() |
Cut off the deployment section of the curtain shield airbag assembly.
![]() |
Using braided wire, tie down the curtain shield airbag assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *a | Wire Diameter |
![]() |
Position the curtain shield airbag assembly inside the tire as shown in the illustration.
| *a | Width |
| *b | Inner Diameter |
Install SST.
![]() |
Connect the clip and terminal of SST.
| *a | Connect the clip and terminal |
After connecting the following SST to each other, connect them to the curtain shield airbag assembly.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the curtain shield airbag assembly is tied.
| *1 | Tires (2 or more) |
Place at least 2 tires onto the tire to which the curtain shield airbag assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
![]() |
Deploy the airbag.
| *1 | Curtain Shield Airbag Assembly |
| *2 | Battery |
| *a | 10 m (32.8 ft.) or more |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the curtain shield airbag assembly is tied.
Connect the clip of SST to the positive (+) battery terminal.
Connect the terminal of SST to the negative (-) battery terminal to deploy the curtain shield airbag assembly.
Dispose of the curtain shield airbag assembly.
Remove the curtain shield airbag assembly from the tire.
Place the curtain shield airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.