Home › Engine / Hybrid System › FA20 STARTING › STARTER (for Automatic Transmission)

STARTER (for Automatic Transmission) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A280967
  1. Temporarily install the upper side bolts.



    A277913
  1. Install the lower side bolt.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Install the bolt.



    A282904E01
  1. Using SST, install the upper side bolt and starter assembly.

    SST
    09249-37010  

    Torque:
    without SST:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }
    with SST:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 260 mm (10.2 in.). When using a torque wrench with a fulcrum length that is not 260 mm (10.24 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.

  1. Engage the wire clamp.

  1. Connect the starter connector.

  1. Connect the starter wire with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL FRONT EXHAUST PIPE ASSEMBLY
  1. Temporarily install the front exhaust pipe assembly to the bracket with the bolt.

  1. Install the new gaskets and the front exhaust pipe assembly to the center exhaust pipe assembly with the 2 nuts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    1. Do not reuse the gaskets.
    2. Do not reuse the nuts.

  1. Install the new gaskets and the front exhaust pipe assembly to the front exhaust pipe sub-assembly with the 2 new nuts.

    Torque:
    43 N*m{ 439 kgf*cm , 32 ft.*lbf }

    NOTICE:
    1. Do not reuse the gaskets.
    2. Do not reuse the nuts.

  1. Fully tighten the bolt.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



3. INSTALL NO. 2 ENGINE UNDER COVER
  1. Install the 7 bolts and the No. 2 engine under cover.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL