STARTER (for Manual Transmission) > INSTALLATION |
| 1. INSTALL STARTER ASSEMBLY |
![]() |
Temporarily install the upper side bolts.
![]() |
Install the lower side bolt.
Install the bolt.
![]() |
Using SST, install the upper side bolt and starter assembly.
Engage the wire clamp.
Connect the starter connector.
Connect the starter wire with the nut.
| 2. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Temporarily install the front exhaust pipe assembly to the bracket with the bolt.
Install the new gaskets and the front exhaust pipe assembly to the center exhaust pipe assembly with the 2 nuts.
Install the new gaskets and the front exhaust pipe assembly to the front exhaust pipe sub-assembly with the 2 new nuts.
Fully tighten the bolt.
| 3. INSTALL NO. 2 ENGINE UNDER COVER |
Install the 7 bolts and the No. 2 engine under cover.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |