Home › Engine / Hybrid System › FA20 STARTING › STARTER (for Automatic Transmission)

STARTER (for Automatic Transmission) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL



2. REMOVE NO. 2 ENGINE UNDER COVER


    A278295
  1. Remove the 7 bolts and the No. 2 engine under cover.



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A277952
  1. Remove the 2 nuts and disconnect the exhaust joint pipe.



    A277953
  1. Remove the 2 nuts and the 2 bolts.

  1. Remove the 2 compression springs and disconnect the center exhaust pipe assembly.



    A277954
  1. Remove the bolt and the front exhaust pipe assembly.

  1. Remove the 2 gaskets.



4. REMOVE STARTER ASSEMBLY


    A280965
  1. Remove the nut and disconnect the starter wire.

  1. Disconnect the starter connector.



    A279742E01
  1. Disengage the wire clamp.



    A280967
  1. Remove the upper side bolt.



    A285321
  1. Remove the bolt.



    A277913
  1. Remove the lower side bolt, battery cable stay and starter assembly.