Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR CALIPER ASSEMBLY


    C256615
  1. Remove the 2 bolts and separate the rear disc brake caliper assembly LH.

    NOTICE:
    Hang the rear disc brake cylinder assembly LH with wire or equivalent.



3. REMOVE REAR DISC


    C186060E02
  1. Place matchmarks on the rear disc and rear axle hub.
    Text in Illustration 
    *a
    Matchmark

    HINT:
    It is not necessary when replacing the rear disc.



    C256659E01
  1. Release the parking brake and remove the rear disc.

    HINT:
    If it is difficult to remove the rear disc, insert a screwdriver through the hole of rear disc and turn the adjusting screw to contract it.

    Text in Illustration 
    *a
    Contract
    *b
    Expand



4. REMOVE REAR AXLE HUB BOLT LH


  1. Using SST, remove the rear axle hub bolt LH from rear axle hub and bearing assembly LH.


    C265373E01


    Text in illustration 
    *1
    Nut
    *2
    Body
    *3
    Claw
    *4
    SST (Spacer B)
    *a
    Place a Wrench Here
    -
    -
    V100135
    Molybdenum Grease
    V100136
    Turn
    SST
    09960-20010   (09961-02010, 09961-02060)

    CAUTION:
    Before working, apply molybdenum grease to the bolt threads and bolt tip of SST.

    NOTICE:
    1. Install SST so that claw and body are parallel
    2. Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
    3. Do not damage the parking brake plate sub-assembly.
    4. Do not damage the rear axle carrier.
    5. Do not damage the rear axle hub and bearing.



5. INSTALL REAR AXLE HUB BOLT LH


    C123492E01
  1. Set a new axle hub bolt onto the rear axle hub and bearing, and tighten the nut (M12 x P1.25mm (0.0492 in.)) through the washer plate to install the axle hub bolt.
    Text in Illustration 
    *1
    Nut
    *2
    Washer
    *a
    Turn
    *b
    Hold

    NOTICE:
    Install the nuts to prevent damage to the rear axle hub bolt LHs LH.



6. INSTALL REAR DISC
  1. Align the matchmarks placed when removing, install the rear disc to the axle hub.

    HINT:
    When using a new rear disc, install it so that rear disc runout is minimum.



7. INSTALL REAR CALIPER ASSEMBLY
  1. Install the rear disc brake caliper assembly LH with the new 2 bolts.

    Torque:
    66 N*m{ 673 kgf*cm , 49 ft.*lbf }



8. INSTALL REAR WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }