Home › Engine / Hybrid System › FA20 FUEL › FUEL PUMP ECU

FUEL PUMP ECU > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY
  1. Attach the fuel pump control ECU assembly bracket to the body attachment hole, and pass the stud bolt through the hole in the body.

  1. Install the fuel pump control ECU assembly with the nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    NOTICE:
    Do not reuse the fuel pump control ECU assembly if it has been subjected to shocks.

  1. Connect the fuel pump control ECU assembly connector.



2. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

HINT:
Use the same procedure as for the for LH side.



3. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH

HINT:
Use the same procedure as for the LH side.



4. INSTALL SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side.



6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure as for the LH side.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL