Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > INSPECTION

for Preparation Click here


CAUTION:
Ensure that fingers or articles of clothing do not get caught by moving parts when performing this test.



1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)


    E132856E03
  1. Check the LO operation.
    OK: 
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 5 (+1)
    Battery negative (-) → Terminal 4 (E)
    Motor operates at low speed (LO)
    If the result is not as specified, replace the windshield wiper motor assembly.

  1. Check the HI operation.
    OK: 
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3 (+2)
    Battery negative (-) → Terminal 4 (E)
    Motor operates at high speed (HI)
    If the result is not as specified, replace the windshield wiper motor assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Windshield Wiper Motor Assembly)



2. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)


    E132856E02
  1. Check the LO operation.
    OK: 
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1 (+1)
    Battery negative (-) → Terminal 5 (E)
    Motor operates at low speed (LO)
    If the result is not as specified, replace the windshield wiper motor assembly.

  1. Check the HI operation.
    OK: 
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4 (+2)
    Battery negative (-) → Terminal 5 (E)
    Motor operates at high speed (HI)
    If the result is not as specified, replace the windshield wiper motor assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Windshield Wiper Motor Assembly)