Home › Engine / Hybrid System › FA20 FUEL › FUEL PUMP

FUEL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP ASSEMBLY


    A095616E16
  1. Inspect the resistance of the fuel pump assembly.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Pump Assembly)
      If the result is not as specified, replace the fuel pump assembly.



    A282938E01
  1. Inspect the operation of the fuel pump assembly.

    1. Connect a battery's negative (-) lead to terminal 3 of the connector, and a positive (+) lead to terminal 4. Check that the fuel pump operates.
      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Suction Tube Assembly with Pump and Gauge)

      NOTICE:
      1. These tests must be performed within 10 seconds to prevent the coil from burning out.
      1. Keep the fuel pump as far away from the battery as possible.
      1. Always turn on and off the voltage on the battery side, and not on the fuel pump side.