AUTOMATIC TRANSMISSION SYSTEM > DTC CHECK / CLEAR |
| Pending DTC | Store condition | Malfunction detected |
| Clear condition | System determined to be normal or DTCs cleared using GTS or Cable disconnected from negative battery terminal | |
| Current DTC | Store condition | Malfunction detected (2nd trip) |
| Clear condition | No malfunctions in 40 driving cycles or DTCs cleared using GTS | |
| Permanent DTC | Store condition | Malfunction detected (2nd trip) |
| Clear condition | One trip is confirmed with no abnormality after no malfunction is detected in 3 consecutive driving cycles or After DTCs cleared using GTS, malfunction not detected when universal trip driving performed | |
| MIL | ON | Malfunction detected (2nd trip) |
| OFF | One trip is confirmed with no abnormality after no malfunction is detected in 3 consecutive driving cycles or DTCs cleared using GTS |


| CHECK DTC |
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus: "Powertrain / ECT / Trouble Codes" or "Body Electrical / Main Body / Trouble Codes".
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Pending and Current DTC) |
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus: "Powertrain / ECT / Trouble Codes" or "Body Electrical / Main Body / Trouble Codes".
Clear the DTCs.
| CLEAR PERMANENT DTC |

Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Check if permanent DTCs are stored.
Clear DTCs.
Perform the universal trip.
Turn the ignition switch off.
Wait 15 seconds.
Turn the ignition switch ON.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Check that the permanent DTCs have been cleared.