AUTOMATIC TRANSMISSION SYSTEM > CHECK MODE PROCEDURE |
| DTC CHECK (CHECK MODE) |
Procedure for Check Mode using the GTS.
Check the initial conditions.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch ON and turn the GTS main switch on.
Enter the following menus: Powertrain / ECT / Utility / Check Mode.
Start the engine (the MIL goes off after the engine starts).
Perform "MONITOR DRIVE PATTERN" for the ECT test (Click here), or simulate the conditions of the malfunction described by the customer.
After simulating malfunction conditions, use the GTS diagnosis selector to check the DTCs and freeze frame data, etc.
When you use GTS: Enter the following menus: Powertrain / ECT / Trouble Codes.
After checking the DTC, inspect the applicable circuit.
(Click here) to confirm the details of the DTCs.
| DTC CLEAR |
Connect the GTS to the DLC3.
Turn the ignition switch ON and turn the GTS main switch on.
When you use GTS: Enter the following menus: Powertrain / ECT / Trouble Codes / Clear.