Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > DEFINITION OF TERMS

for Preparation Click here



Term
Definition
Monitor description
Description of what the TCM monitors and how it detects malfunctions (monitoring purpose and its details).
Related DTCs
Diagnostic code
Typical enabling condition
Preconditions that allow the TCM to detect malfunctions.
With all preconditions satisfied, the TCM sets the DTC when the monitored value(s) exceeds the malfunction threshold(s).
Sequence of operation
The priority order that is applied to monitoring, if multiple sensors and components are used to detect the malfunction.
While another sensor is being monitored, the next sensor or component will not be monitored until the previous monitoring has concluded.
Required sensor/components
The sensors and components that are used by the TCM to detect malfunctions.
Frequency of operation
The number of times that the TCM checks for malfunctions per driving cycle.
"Once per driving cycle" means that the TCM detects malfunction only one time during a single driving cycle.
"Continuous" means that the TCM detects malfunction every time when enabling condition is met.
Duration
The minimum time that the TCM must sense a continuous deviation in the monitored value(s) before setting a DTC. This timing begins after the "typical enabling conditions" are met.
Malfunction thresholds
Beyond this value, the TCM will conclude that there is a malfunction and set a DTC.
MIL operation
MIL illumination timing after a defect is detected.
"Immediately" means that the TCM illuminates MIL the instant the TCM determines that there is a malfunction.
"2 driving cycle" means that the TCM illuminates MIL if the same malfunction is detected again in the 2nd driving cycle.
Component operating range
Normal operation range of sensors and solenoids under normal driving conditions.
Use these ranges as a reference.
They cannot be used to judge if a sensor or solenoid is defective or not.