Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR

FRONT SPEED SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. The procedures listed below are for the LH side.
  2. Use the same procedures for the RH and LH sides.



1. INSTALL FRONT SPEED SENSOR LH
  1. Install the front speed sensor LH with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and the front disc brake dust cover.

  1. Connect the 6 front speed sensor clamps.

    NOTICE:
    Securely connect the connector.



2. INSTALL FRONT FENDER LINER LH
  1. Install the front fender liner LH with the 18 clips.

  1. Install the new grommet.

  1. Install the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



3. INSTALL FRONT WHEEL LH

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



4. INSPECT SPEED SENSOR SIGNAL
(Click here)