Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR

FRONT SPEED SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. The procedures listed below are for the LH side.
  2. Use the same procedures for the RH and LH sides.



1. REMOVE FRONT WHEEL LH


2. REMOVE FRONT FENDER LINER LH


B310889
  1. Remove the bolt.

  1. Remove the grommet.

    HINT:
    The grommet need to be replaced with new ones because they will break when they are removed.



    B310890
  1. Using a clip remover, disengage the 18 clips and remove the front fender liner LH.



3. REMOVE FRONT SPEED SENSOR LH


    C257472
  1. Disconnect the front speed sensor connector.



  1. Disconnect the 6 clamps.


    C257523



    C257545
  1. Remove the bolt and front speed sensor LH from the steering knuckle.

    NOTICE:
    Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.