Home › Engine / Hybrid System › FA20 FUEL › FUEL INJECTOR (for Direct Injection)

FUEL INJECTOR (for Direct Injection) > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY

NOTICE:
This inspection aims is to inspect the fuel injectors for opens or shorts, because the fuel injectors of this vehicle are of a high-pressure type and cannot be inspected for fuel injection volume.



    A281868E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    1.9 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Injector Assembly)
    If the result is not as specified, replace the fuel injector assembly.