Home › Engine / Hybrid System › FA20 FUEL › FUEL PRESSURE SENSOR

FUEL PRESSURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL PRESSURE SENSOR


A107670E10
  1. Check the fuel pressure sensor output voltage.

    1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      1 (GND) - 2 (VOUT)
      Apply 5 V between terminals 3 (VCC) and 1 (GND)
      Approximately 0.5 V

      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Pressure Sensor)

      NOTICE:
      1. Be careful when connecting the leads, as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
      2. Do not apply a voltage of 6 V or more to the terminals 3 (VCC) and 1 (GND).

      HINT:
      If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries, etc.

      If the resistance is not as specified, replace the fuel pressure sensor.