Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY

REAR SEAT OUTER BELT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear seat 3 point type outer belt assembly.



1. INSPECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
  1. Visually check for defects with the rear seat 3 point type outer belt assembly installed on the vehicle.

    1. The defects are as follows:

      1. Cuts on the rear seat 3 point type outer belt assembly
      2. Small cracks on the rear seat 3 point type outer belt assembly
      3. Significant discoloration on the rear seat 3 point type outer belt assembly

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the rear seat 3 point type outer belt assembly with a new one.



2. INSPECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
  1. Visually check for defects with the rear seat 3 point type outer belt assembly removed from the vehicle.

    1. The defects are as follows:

      1. Cuts on the rear seat 3 point type outer belt assembly
      2. Small cracks on the rear seat 3 point type outer belt assembly
      3. Significant discoloration on the rear seat 3 point type outer belt assembly
      4. Cracks or other damage to the connector

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the rear seat 3 point type outer belt assembly with a new one.