Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR CALIPER ASSEMBLY


    C256615
  1. Remove the 2 bolts and separate the rear disc brake caliper assembly LH.

    NOTICE:
    Hang the rear disc brake cylinder assembly LH with wire or equivalent.



3. REMOVE REAR DISC


    C186060E02
  1. Place matchmarks on the rear disc and rear axle hub.
    Text in Illustration 
    *a
    Matchmark

    HINT:
    It is not necessary when replacing the rear disc.



    C256659E01
  1. Release the parking brake and remove the rear disc.

    HINT:
    If it is difficult to remove the rear disc, insert a screwdriver through the hole of rear disc and turn the adjusting screw to contract it.

    Text in Illustration 
    *a
    Contract
    *b
    Expand



4. INSPECT REAR AXLE HUB BEARING LOOSENESS


    C259946
  1. Using a dial indicator, check for looseness near the center of the rear axle hub.

    Maximum looseness:
    0.05 mm (0.00196 in.)

    NOTICE:
    1. Make sure that the dial indicator is set perpendicular to the measurement surface.
    2. Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

    If the looseness is more than the maximum, replace the rear axle hub and bearing assembly.



5. INSPECT REAR AXLE HUB RUNOUT


    C259947
  1. Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.

    Maximum runout:
    0.05 mm (0.00196 in.)

    NOTICE:
    1. Make sure that the dial indicator is set perpendicular to the measurement surface.
    2. Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

    If the runout is more than the maximum, replace the rear axle hub and bearing assembly.



6. INSTALL REAR DISC
  1. Align the matchmarks placed when removing, install the rear disc to the axle hub.

    HINT:
    When using a new rear disc, install it so that rear disc runout is minimum.



7. INSTALL REAR CALIPER ASSEMBLY
  1. Install the rear disc brake caliper assembly LH with the new 2 bolts.

    Torque:
    66 N*m{ 673 kgf*cm , 49 ft.*lbf }



8. INSTALL REAR WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }