Home › Vehicle Exterior › DOOR / HATCH › HOOD

HOOD > ADJUSTMENT

for Preparation Click here


B227882E01

HINT:
  1. Use the same procedure for the LHD and RHD vehicles.
  2. The procedure listed below is for the LHD vehicles.
  3. Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
  4. Specified torque for standard bolts is shown in the standard bolt chart (Click here).

Text in Illustration 
*1
Centering Bolt
*2
Standard Bolt


1. INSPECT HOOD SUB-ASSEMBLY


  1. Check that the clearance measurements of areas *a through *e are within each standard range.


    B313104E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    *a
    5.8 to 9.8 mm (0.2283 to 0.3858 in.)
    *b
    3.0 to 7.0 mm (0.1181 to 0.2756 in.)
    *c
    -2.0 to 2.0 mm (-0.0787 to 0.0787 in.)
    *d
    2.0 to 5.0 mm (0.0787 to 0.1969 in.)
    *e
    -2.0 to 1.0 mm (-0.0787 to 0.0394 in.)
    -
    -



2. ADJUST HOOD SUB-ASSEMBLY


  1. Horizontally and vertically adjust the hood.



      B312163
    1. Loosen the 4 hinge bolts of the hood.

    2. Adjust the clearance between the hood and front fender by moving the hood.

    3. Tighten the 4 hinge bolts after the adjustment.

      Torque:
      18 N*m{ 184 kgf*cm , 13 ft.*lbf }



  1. Adjust the height of the front end of the hood using the cushion rubbers.



      B312164
    1. Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.

      HINT:
      Raise or lower the front end of the hood by turning the 2 cushion rubbers.



  1. Adjust the hood lock.

    1. Loosen the 3 bolts.



    2. B314955
    3. Adjust the hood lock position so that the striker can enter it smoothly.



    4. B313112E02
    5. Tighten the 3 bolts after the adjustment in the order shown in the illustration.

      Torque:
      33 N*m{ 337 kgf*cm , 24 ft.*lbf }

    6. Check that the striker can engage smoothly with the hood lock.