Home › Vehicle Exterior › DOOR / HATCH › HOOD

HOOD > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HOOD SUB-ASSEMBLY


  1. Check that the clearance measurements of areas *a through *e are within each standard range.


    B313104E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    *a
    5.8 to 9.8 mm (0.2283 to 0.3858 in.)
    *b
    3.0 to 7.0 mm (0.1181 to 0.2756 in.)
    *c
    -2.0 to 2.0 mm (-0.0787 to 0.0787 in.)
    *d
    2.0 to 5.0 mm (0.0787 to 0.1969 in.)
    *e
    -2.0 to 1.0 mm (-0.0787 to 0.0394 in.)
    -
    -