Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR

LUGGAGE COMPARTMENT DOOR > ADJUSTMENT

for Preparation Click here


B146067E02

HINT:
  1. Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).

Text in Illustration 
*1
Centering Bolt
*2
Standard Bolt


1. INSPECT LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY


  1. Check that the clearance measurements of areas *a to *f are within each standard range.


    B310904E01


    Standard Clearance:

    Area
    Measurement
    Area
    Measurement
    *a
    8.2 mm (0.3228 in.)
    *b
    2.0 to 5.0 mm (0.0787 to 0.1969 in.)
    *c
    -2.0 to 1.0 mm (-0.0787 to 0.0394 in.)
    *d
    5.8 to 10.2 mm (0.2283 to 0.4016 in.)
    *e
    4.3 to 7.3 mm (0.1693 to 0.2874 in.)
    *f
    -2.0 to 1.0 mm (-0.0787 to 0.0394 in.)



2. ADJUST LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY


    B310950
  1. Horizontally and vertically adjust the door by loosening the door side hinge bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



    B310951
  1. When adjusting the rear edge of the doors left or right, or adjusting the luggage door closer assembly, loosen the bolts before making adjustments.

  1. Using a brass bar and a hammer, hit the striker to adjust its position.

  1. After the adjustment, tighten the 2 bolts on the luggage door closer assembly.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }