Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function)

DTC    B2277    Detecting Vehicle Submersion

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction in the water submersion detection circuit in the certification ECU (smart key ECU assembly) is detected.

DTC No.
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B2277
The water submersion detection circuit in the certification ECU (smart key ECU assembly) detects water submersion (1-trip detection logic*).
  1. Submersion of certification ECU (smart key ECU assembly) in water
  2. Certification ECU (smart key ECU assembly)
Wait 300 seconds after connecting the battery cable.
*: Only output while a malfunction is present and the engine switch is on (IG)

Vehicle Condition and Fail-safe Function when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Function when Malfunction Detected
The engine cannot be turned off and the engine cannot be started.
The power source mode changes to on (IG) and starter relay activation is prohibited.

Related Data List and Active Test Items 
DTC No.
Data List Item
Active Test Item
B2277
-
-

INSPECTION PROCEDURE

NOTICE:
  1. When using the GTS with the engine switch off to troubleshoot:
    Connect the GTS to the DLC3 and turn a courtesy light switch on and off at 1.5-second intervals until communication between the GTS and vehicle begins.
  2. The entry and start system uses multiplex communication. First perform the inspections in "How to Proceed with Troubleshooting" to confirm that there are no communication malfunctions before proceeding with troubleshooting (Click here).
  3. Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Entry Function) (Click here).
  4. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

HINT:
Before proceeding with troubleshooting, check if there are any signs of water damage to the certification ECU (smart key ECU assembly). If there are any signs of water damage, replace the certification ECU (smart key ECU assembly) and take measures against the cause of the water damage.

1.CHECK FOR WATER DAMAGE
  1. Check the certification ECU (smart key ECU assembly), peripheral components, and wire harnesses for traces of water.
    Result 
    Result
    Proceed to
    There are traces of water
    A
    There are no traces of water
    B



B
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
A

TAKE APPROPRIATE MEASURES AGAINST CAUSE OF WATER DAMAGE AND REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)