Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here



CHECK FOR INTERMITTENT PROBLEMS

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harness can be detected using the Data List function of the GTS.

  1. Turn the ignition switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the GTS on.

  5. Follow the directions on the GTS to display the Data List and select areas where momentary interruption should be monitored.

    HINT:
    1. A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
    2. If Error remains displayed for one of the items on the GTS, check for continuity between the ECU and the item for which Error is displayed.
    3. If a momentary interruption occurs and Error is displayed on the GTS, Error will remain displayed on the GTS for 1 second after the circuit returns to normal.


    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG Voltage Value Decreased
    IG voltage value decrease detection / Error or Normal
    Error: Voltage low
    Normal: Normal
    -
    IG Voltage Value Increased
    IG voltage value increase detection / Error or Normal
    Error: Voltage high
    Normal: Normal
    -

  6. While observing the screen, gently jiggle the connector or wire harness.

    OK:
    Normal is displayed.

    HINT:
    If the display changes, this indicates that there has been a momentary interruption (open circuit) in the connector and/or wire harness. In this case, repair or replace the connectors and/or wire harnesses as one of them is faulty.