Component
| Outline
|
Engine switch
| - Turns on the power and starts the engine.
- Contains a built-in transponder key amplifier to start the engine when the key does not operate properly due to a depleted battery or wave interference.
|
Certification ECU (smart key ECU assembly)
| - Performs key verification.
- Controls the electrical key antenna (outside), electrical key antenna (indoor) and door lock/unlock sensor.
- Receives the open signal from the back door opener switch assembly and outputs a signal to the main body ECU (network gateway ECU) via CAN communication.
- Outputs entry door lock/unlock commands.
- Outputs steering lock actuator assembly lock/unlock command signals.
- Outputs immobiliser set/unset commands.
- Controls the theft warning indicator light.
- Controls the entry key indicator light in the combination meter assembly.
- Changes the power source mode by operating the ACC and IG relays.
- Forms the entry detection area.
|
ID code box (immobiliser code ECU)*1
| - Receives command signals from the certification ECU (smart key ECU assembly) and outputs immobiliser set and unset command signals to the ECM.
- Records codes for verification.
|
ECM
| - Outputs a signal indicating that the engine has started to the certification ECU (smart key ECU assembly) when starting the engine.
- Controls starting by operating the starter relay.
|
Steering lock actuator assembly (steering lock ECU)
| - Receives command signals from the certification ECU (smart key ECU assembly) and activates the steering lock actuator assembly.
- Records codes for verification.
|
Combination meter assembly
| - Operates various warnings (sounding of the buzzer in the combination meter) according to the command signals from the certification ECU (smart key ECU assembly).
- Notifies the user when the entry and start system has a malfunction.
|
Brake Actuator Assembly (Skid Control ECU)
| Outputs a vehicle speed signal to the certification ECU (smart key ECU assembly).
|
IG, ACC relay
| Turns on/off according to certification ECU (smart key ECU assembly) control and provides power to each system.
|
Stop light switch assembly*2
| Detects that the brake pedal has been depressed (switch is on) and outputs a signal to the certification ECU (smart key ECU assembly).
|
Clutch start switch assembly*3
| Detects that the clutch pedal has been depressed (switch is on) and outputs a signal to the certification ECU (smart key ECU assembly).
|
Park/neutral position switch assembly*2
| Outputs the shift position to the certification ECU (smart key ECU assembly)
|
Shift lock control ECU*2
| Outputs a shift lock control ECU signal to the certification ECU (smart key ECU assembly).
|
Indoor electrical key oscillator (front floor) No. 2 indoor electrical key oscillator (rear floor)
| Sends the request code from the certification ECU (smart key ECU assembly) and forms the vehicle interior detection area.
|
Door control receiver
| Receives the entry and start system code / wireless code sent from the key and sends it to the certification ECU (smart key ECU assembly).
|
Electrical key transmitter sub-assembly
| Sends the ID code upon receiving a request signal.
|