Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU AND RECEIVER

HINT:
Inspect the connectors from the back side while the connectors are connected.


E129452E57

  1. Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H28-1 (IG) - H28-12 (GND)
    W - B
    IG power source
    Ignition switch ON
    11 to 14 V
    H28-4 (BRDA) - H28-12 (GND)
    R - B
    Output signals
    Ignition switch ON
    Pulse generation (see waveform 1)
    H28-5 (BPRG) - H28-12 (GND)
    P - B
    Input signals
    Ignition switch ON
    Pulse generation (see waveform 1)
    H28-7 (+B) - H28-12 (GND)
    Y-R - B
    Power Supply
    Always
    11 to 14 V
    H28-12 (GND) - Body ground
    B - Body ground
    Ground
    Always
    Below 1 Ω



  2. C240058E01
  3. Using an oscilloscope, check waveform 1.
    Text in Illustration 
    *a
    Example
    *b
    GND
    Waveform 1: 
    Item
    Contents
    Terminal
    H28-4 (BRDA) - H28-12 (GND)
    H28-5 (BPRG) - H28-12 (GND)
    Tool setting
    5 V/DIV, 50 μs./DIV.
    Vehicle condition
    Ignition switch ON

    HINT:
    The waveform shown in the illustration is an example. If the tester displays a waveform that alternates between high and low, where high is a voltage that is between the IG power source voltage and a voltage 2.2 V lower than the IG power source voltage, and where low is a voltage of between 0 and 1.2 V, the ECU can be judged normal.