TIRE PRESSURE WARNING SYSTEM > TEST MODE PROCEDURE |
| TEST MODE (SIGNAL CHECK MODE) PROCEDURE |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.
![]() |
| *a | 0.125 sec. |
| *b | ON |
| *c | OFF |
Wait for 1.5 minutes with the vehicle stopped, or drive the vehicle for 1 minute (C2181/81 to C2184/84).
Check that the tire pressure warning system test mode (signal check mode) DTCs are cleared.
| Test Mode (Signal Check Mode) DTC | Test Signal | Test Mode (Signal Check Mode) DTC Clear Condition |
| C2181/81 to C2184/84 | Transmitter Data | Data is received from the relevant transmitter which has a registered ID in the tire pressure warning ECU and receiver. |
Result
| Condition | Procedure |
| Test mode (signal check mode) DTC is output | Repair the faulty part and enter Signal Check again |
| Test mode (signal check mode) DTCs are cleared | No problem |
End of test mode (signal check mode)
After completing the test mode (signal check mode), turn the ignition switch off and disconnect the GTS.
Test mode (signal check mode) DTCs
If a trouble code is displayed during the test mode (signal check mode) DTC check, check the diagnosis procedure listed for that code. For details of each code, refer to See page below.
| DTC No. | Detection Item | Trouble Area | See page |
| C2181/81 | Transmitter ID1 not received |
|
Click here
|
| C2182/82 | Transmitter ID2 not received |
|
Click here
|
| C2183/83 | Transmitter ID3 not received |
|
Click here
|
| C2184/84 | Transmitter ID4 not received |
|
Click here
|