STEERING LOCK SYSTEM > PRECAUTION |
| 1.PRECAUTIONS WHEN CHECKING FOR DTCS |
When the cable is disconnected from the negative (-) battery terminal, the DTCs stored in the steering lock actuator assembly (steering lock ECU) are cleared. Be sure to record any output DTCs immediately.
Normally, with the engine switch off (lock), even if the GTS is connected to the vehicle, the information stored in the entry and start system related ECUs (the certification ECU (smart key ECU assembly), main body ECU (network gateway ECU), etc.) cannot be read. However, entry and start system DTCs and Data List information can be confirmed even if the engine switch is off (lock) using either of the two methods below:
| 2.PRECAUTIONS WHEN REPLACING STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) |
If the steering lock actuator assembly (steering lock ECU) is replaced, be sure to confirm that the steering is unlocked by turning the steering wheel to the left and right before starting the engine. If the steering is locked for any reason, open and close a door with the engine switch off, and then unlock the steering by pressing the engine switch. This prevents the engine from starting while the steering is locked.
| 3.PRECAUTION FOR REGISTRATION |
If replacing any of the following parts, refer to the Service Bulletin.
ID code box (immobiliser code ECU)*
Certification ECU (Smart key ECU assembly)
Steering lock actuator assembly (steering lock ECU)
ECM
Electrical key transmitter (key)
*: w/ ID Code Box