Home › Engine / Hybrid System › FA20 COOLING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. FAN NO. 1 RELAY


    A167865E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the relay.



2. FAN NO. 2 RELAY


    A159206E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage is not applied between terminals 1 and 2
    Below 1 Ω
    Battery voltage is applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the relay.



3. FAN NO. 3 RELAY


    A167865E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the relay.