Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Data List.

  5. Read the Data List according to the display on the GTS.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Wireless Control
    Wireless door lock control function / OFF or ON
    Customized setting displayed
    -
    Wireless Buzzer Resp*1
    Wireless buzzer response / OFF or ON
    Customized setting displayed
    -
    Hazard Answer Back
    Hazard answer-back of wireless / OFF or ON
    Customized setting displayed
    -
    Open Door Warning*2
    Open door warning / OFF or ON
    Customized setting displayed
    -
    Unlock 2 Operation*3, *4
    2 times operation of wireless unlock / OFF or ON
    Customized setting displayed
    -
    Panic Function*3
    Panic function / OFF or ON
    Customized setting displayed
    -
    Wireless Auto Lock
    Automatic lock function / OFF or ON
    Customized setting displayed
    -
    Auto Lock Time
    Automatic lock time / 30 s, 60 s or 120 s
    Customized setting displayed
    -
    Trunk Lid Operation
    Opening the luggage compartment door by the door control transmitter module set sub-assembly/ 1 tim ON, 2 tim ON, Long1 or Long2
    Customized setting displayed
    -
    Wireless Buzzer Vol*1
    Wireless door lock buzzer volume/Level7, Level6, Level5, Level4, Level3, Level2, Level1 or Level0
    Customized setting displayed
    -
    Detection of Vehicle
    Detection of vehicle function OFF or ON
    Customized setting displayed
    -
    D Door Courtesy SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door opened
    OFF: Driver side door closed
    -
    P Door Courtesy SW
    Passenger side door courtesy light switch signal / ON or OFF
    ON: Passenger side door opened
    OFF: Passenger side door closed
    -
    Luggage Courtesy SW
    Luggage compartment door courtesy switch signal / OFF or ON
    ON: Luggage compartment door is open
    OFF: Luggage compartment door is closed
    -
    IG SW
    Ignition switch IG signal / ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -
    ACC SW
    Ignition switch ACC signal / ON or OFF
    ON: Ignition switch ACC
    OFF: Ignition switch off
    -
    Key Unlock Warning SW
    Unlock warning switch / OFF or ON
    OFF: Ignition key is not inserted
    ON: Ignition key is inserted
    -
    Hazard Output
    Hazard warning light output / OFF or ON
    OFF: Not during hazard answerback operation
    ON: During hazard answer-back operation
    -
    Wireless Buzzer Output*1
    Wireless door lock buzzer output / OFF or ON
    OFF: Not during wireless door lock buzzer answer-back operation
    ON: During wireless door lock buzzer answer-back operation
    -

    1. *1: w/ Wireless Door Lock Buzzer Answer-back Function
    2. *2: w/ Door Ajar Warning Function
    3. *3: w/ Panic Alarm Control Function
    4. *4: w/ Double locking System


PERFORM ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. Perform the Active Test according to the display on the GTS.


Main Body 
Tester Display
Test Part
Control Range
Diagnostic Note
Door Lock
Door lock motor
Unlock / Lock
-
D-Door Unlock
Driver side door lock motor
OFF / ON
-
Trunk and Back-Door Open
Luggage door lock motor
OFF / ON
-
Illuminated Entry System
Interior lights (Interior light switch is in door position and all doors are closed)
OFF / ON
-
Wireless Buzzer*
Wireless door lock buzzer
OFF / ON
-
Hazard
Turn signal flasher assembly
OFF / ON
-
Door Open/Close State
Main body ECU (network gateway ECU)
OFF / ON
-
  1. *: w/ Wireless Door Lock Buzzer Answer-back Function