Home › Engine / Hybrid System › FA20 COOLING › RADIATOR

RADIATOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK RADIATOR CAP SUB-ASSEMBLY


    A110260
  1. Measure the valve opening pressure.

    1. If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.

    2. Check that rubber packings 1, 2 or 3 are not deformed, cracked or swollen.

    3. Check that rubber packings 3 and 4 are not stuck together.

    4. Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.



    5. A104601E06
    6. When using the cap tester, tilt it 30° or more.
      Text in Illustration 
      *1
      Radiator Cap Tester
      *2
      Radiator cap sub-assembly
      *a
      30° or more

    7. Pump the cap tester several times, and check the maximum pressure*1.

      Pumping speed:
      1 pump per second

      HINT:
      *1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Judgment Criterion:
      Item
      Specified Condition
      Standard valve
      (for brand-new cap)
      93 to 123 kPa (0.95 to 1.25 kgf/cm2, 14 to 18 psi)
      Minimum standard valve
      (for used cap)
      83 kPa (0.85 kgf/cm2, 12 psi)

      If the maximum pressure is less than the minimum standard valve, replace the radiator cap sub-assembly.