Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B315201
  1. Disengage the 6 claws and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM BOARD LH


    B315202
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board LH.



3. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B313107
  1. Remove the bolt and hood lock control lever sub-assembly.

  1. Disconnect the hood lock control cable assembly from the hood lock control lever sub-assembly.



4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE



5. REMOVE HOOD LOCK ASSEMBLY


    B313108
  1. Remove the 3 bolts and hood lock assembly.

  1. Disconnect the hood lock control cable assembly from the hood lock assembly.



6. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver, disengage 6 clamps shown in the illustration.


    B313109E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Grommet
    *3
    Hood Cable Grommet
    -
    -

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the hood lock control cable assembly from the engine compartment and remove it.