Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side .



2. REMOVE COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side .



3. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B313090
  1. Remove the bolt and hood lock control lever sub-assembly.

  1. Disconnect the hood lock control cable assembly from the hood lock control lever sub-assembly.



4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE



5. REMOVE HOOD LOCK ASSEMBLY


    B309228
  1. Remove the 3 bolts and hood lock assembly.

  1. Disconnect the hood lock control cable assembly from the hood lock assembly.



6. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver, disengage 7 clamps shown in the illustration.


    B310902E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Grommet
    *3
    Hood Cable Grommet
    -
    -

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the hood lock control cable assembly from the engine compartment and remove it.