DOOR CONTROL TRANSMITTER (w/o Entry and Start System) > INSPECTION |
| 1. INSPECT DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY |
Inspect the operation of the door control transmitter module set sub-assembly.
Remove the transmitter battery (lithium battery: CR2016) from the door control transmitter module set sub-assembly.
Install a new or normal transmitter battery (lithium battery: CR2016).
![]() |
If a new or normal transmitter battery is not available, connect 2 new dry cell batteries (1.5 V) in series. Connect the positive (+) battery electrode to the battery receptacle side terminal, and the negative (-) battery electrode to the bottom terminal, and apply a voltage of 3 V to the transmitter.
| *1 | Dry Cell Batteries |
In a location that is approximately 1 m (3.28ft.) away from the driver door outside handle, point the transmitter at the vehicle and check the operation of the transmitter by pressing the transmitter switches on the transmitter body.
Install the battery (lithium battery: CR2016).
Inspect the battery charge.
![]() |
Remove the battery from the door control transmitter module set sub-assembly that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) or less in diameter including wire sheath) with tape or equivalent to the negative terminal.
| *1 | Wire |
![]() |
Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.
![]() |
Check the transmitter battery voltage.
| Tester Connection | Condition | Specified Condition |
| Battery positive (+) - Battery negative (-) | Ignition switch off, all doors closed and lock or unlock switch is pressed | 2.2 to 3.2 V |