Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL TRANSMITTER (w/o Entry and Start System)

DOOR CONTROL TRANSMITTER (w/o Entry and Start System) > REMOVAL

for Preparation Click here


NOTICE:
Take extra care when handling these precision electronic components.



1. REMOVE TRANSMITTER HOUSING COVER


    B311586E01
  1. Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not use excessive force when prying apart the housing cover.



2. REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    B250774E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the door control transmitter module set sub-assembly.
    Text in Illustration 
    *1
    Protective Tape



3. REMOVE DOOR CONTROL TRANSMITTER PACKING
  1. Remove the door control transmitter packing.



4. REMOVE TRANSMITTER BATTERY


    B250770
  1. Disengage the hook and remove the transmitter battery cover.



    B250771
  1. Remove the transmitter battery (lithium battery: CR2016).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Do not use excessive force when prying up the battery (lithium battery: CR2016) as this may damage the terminals.
    3. Do not touch the battery with wet hands. Water may cause it to rust.
    4. Do not touch or move any components inside the transmitter as this may interfere with its proper operation.
    5. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter from being damaged.

    HINT:
    Tape the screwdriver tip before use.