Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR SUPPORT

LUGGAGE COMPARTMENT DOOR SUPPORT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The following procedure is for the LH side.



1. REMOVE LUGGAGE COMPARTMENT DOOR SUPPORT ASSEMBLY

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the door support.



    B310908E01
  1. Using a screwdriver, remove the 2 stop rings along the groove.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Stop Ring

    HINT:
    Tape the screwdriver tip before use.

  1. Release the ball joint and remove the luggage compartment door support.

    NOTICE:
    Remove the luggage compartment door support while supporting the luggage compartment door by hand.