Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH
  1. Affix the front shock absorber assembly LH perpendicularly.

  1. Push the piston rod down approximately 70 mm (2.756 in.) by hand.



    C265376
  1. Using a metal saw or the like, slowly cut a hole in the location shown in the illustration and let the gas out.
    Text in Illustration 
    V100144
    Area to Cut a Hole

    NOTICE:
    1. Wear protective glasses.
    2. Since the discharging gas may cause chips to scatter, cover the metal saw with a piece of cloth when making the hole.

    HINT:
    The gas is colorless, odorless and non-poisonous.