Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. The procedure listed below is for the LH side.
  2. Use the same procedure for the RH side and LH side.



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT SPEED SENSOR LH


    C256593
  1. Remove the 2 clamps and separate the front speed sensor LH from the front shock absorber with coil spring.



3. SEPARATE FRONT FLEXIBLE HOSE


    C256594
  1. Remove the bolt and separate the front flexible hose from the front shock absorber with coil spring.



4. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH


    C256592
  1. Remove the nut and separate the front stabilizer link assembly LH from the front shock absorber with coil spring.
    If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.



5. REMOVE FRONT SUSPENSION SUPPORT DUST COVER LH

HINT:
If it is necessary to disassemble the front shock absorber with coil spring, remove the front suspension support dust cover LH.



    C261001
  1. Remove the front suspension support dust cover LH.



6. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    C256595E02
  1. Support the front axle using a jack and wooden block.
    Text in Illustration 
    *1
    Wooden Block



    C256596
  1. Remove the 2 bolts and 2 nuts, and separate the front shock absorber with coil spring (lower side) from the steering knuckle.



    C256598
  1. Remove the 3 nuts from the front upper coil spring insulator LH.

  1. Remove the front shock absorber with coil spring.